-
-
Software Zone Fanatic
Vedi qui.
http://www.canon.com.sg/bubblejet/bj..._features.html
A vederlo così sembra tipo l'HP CP 1700 ed altri modelli, le cui cartucce vanno premute nell'alloggiamento.
-
Software Zone Fanatic
Ho trovato questa FAQ, spero che ti chiarisca le idee.
FAQ For Bubble Jet Printer
Q10 : How to replace an Ink Tank in a BJ Cartridge
A: Leave the BJ cartridge in the printer when replacing an Ink Tank. Make sure the printer's power is on. Make sure you insert the Ink Tank in the correct slot.
1. Remove the front cover. The power light blinks while the cartridge holder is positioned to the centre of the printer.
2. Remove the empty Ink Tank by pressing in on the release tab and then lifting the Ink Tank up and out of its slot.
3. Dispose of the ink tank properly, taking care to avoid spilling the ink.
4. Remove the new Ink Tank from its package and pull the orange tape up and against the perforations to open the package film. Be careful not to remove the label from the tank. You will need it to match the tank to the correct slot in the BJ cartridge.
5. Twist the orange protective cap to remove it. Do not attempt to reattach the protective cap; instead, discard it along with the protective tape.
6. Insert the Ink Tank by holding it at a slight angle, aligning it with the correct slot. Press down gently on the top of the tank until it locks into place.
7. Lock the ink tank in place by pressing down on the circle mark on the top of the tank.
8. Close the printer cover. The printer will automatically start cleaning the print heads. When the print heads are clean, the POWER light will stay on, indicating that the printer is ready for operation.
9. Perform another test print to make sure the new ink tanks are performing correctly.
-
Permessi di Scrittura
- Tu non puoi inviare nuove discussioni
- Tu non puoi inviare risposte
- Tu non puoi inviare allegati
- Tu non puoi modificare i tuoi messaggi
-
Regole del Forum
Segnalibri